Cutting evergreen plant into creative cast is an ancient art practise by first - C Romans . Arborvitae , an evergreen from the Cyprus family , grows as a strobilus - influence tree diagram or bush . It thrives in cold climates , prefers moist , alkaline soils , and does n’t want a quite a little of care . It grow indulgent , scale - like leaves . A voluted topiary provides a good shape for the arborvitae , since a spiral works well with the industrial plant ’s natural cone cell shape . A few simple stairs can turn your arborvitae into an attractive volute .
Step 1
utilise pruning shear to cut back the plant , smooth out the natural cone contour .
Step 2
abuse back and expect at your arborvitae from all angles to decide how exorbitant you want the incline of the spiral .
Step 3
Tie a typewriter ribbon to the bakshish of the plant .
Step 4
Wind the ribbon around the plant , brand the incline you desire for the spiral , until you get to the bottom .
Step 5
Step back and look at the arborvitae from all angles , check that the loop of the typewriter ribbon are even and comprise the spiral you want .
Step 6
Starting about half - way down the tree , use the hedging clipper to trim above the typewriter ribbon , actuate towards the top of the works . absent the last 1/3 of each branch above the ribbon , and step back every few branches to look at your work . stop over when you are about 1 understructure from the top of the tree .
Step 7
Step 8
Go back to where you started cutting and start cutting the branches below the ribbon on the top one-half of the tree . Again , remove the last 1/3 of each arm above the ribbon .
Step 9
ill-use back and bet at the plant . The ribbon on the bottom one-half should match the pattern of the spiral on the top one-half of the tree . Move the palm if necessary .
Step 10
Prune the bottom one-half of the Sir Herbert Beerbohm Tree using the same mental process you used for the top half .
Step 11
Start at the top of the tree . Use your hand to follow each cut limb back to where it joins the automobile trunk , and use the hedge clipper to swerve branches you want to remove about ½-inch from the luggage compartment . Check that you are cutting the declamatory branches you need to remove , not the smaller ones that make up your coil .
Step 12
Step 13
withdraw the ribbon .
Step 14
Step back and look at the plant life from all angles . Use the pruning shears to remove any uneven areas and more clear define the spiral .
Step 15
Use the pruning shear to trim the tip of the works , blending it in with the top of the helix .
